![]() ![]() In my case, I wanted to use gcc-4.exe and g -4.exe and so, I went into Settings->Compiler and Debugger->Toolchain executables. For more info, see this cygwin mailing list thread: solution is to point your compiler and linker directly to the version of gcc and g that you want to use. This was how I was able to track down why the issue occurred. The symptom would show up with a message similar to the one below:Įxecution of 'g .exe -Wall -fexceptions -g -c c:/dev/code/cb1/main.cpp -o obj/Debug/main.o' in 'c:\dev\code\cb1' failed.Įxecuting the same command from the CMD.EXE prompt yields an "Access is denied" message. I couldn't find a way to force CB to use a unix-link shell, but was able to find a work around when perusing the Cygwin mailing lists. Packages required (suggested) for MinGW/GCC v4.4.0:Ĭygwin 1.7 changed the way symlinks were created and handled when invoked from a command prompt. Packages required (suggested) for MinGW/GCC v3.4.5: You can install MinGW yourself, by using an automatic downloader/installer or by downloading and unpacking the required packages by hand from, here. Note: In any case, if you don't install MinGW in C:\MinGW, you'll need to update the configuration of GCC in Code::Blocks. Also you can use the TDM's GCC/mingw32 Builds from or. If you install this version, the GCC compiler will be automatically detected and set as the default. A MinGW-bundled version of the latest Code::Blocks release is available from the Code::Blocks download page. ![]() In other words, it is not known yet whether these compilers still work with Code::Blocks. The following publishers have released newer versions of their compilers which should be tested against the current configuration. The following compilers are still supported by Code::Blocks, but are no longer available from their original publishers. These compilers are generally still under active development by their publishers, so a new version of their software could be released that is incompatible with the current version of Code::Blocks. HOWTO: Use Cygwin 1.7 with Code::Blocks. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |